Me! Always thought that club was badass
CaptainFlintlockFinn
Feels like a lot of culture creep. Some of these wing nuts talk about the first amendment as if we have that here. Some of them also seem to think that our Prime Minister has presidential powers. I think the “fuck Trudeau” flags are a rip off of the “fuck Biden” flags too.
I’ll end up voting for them. They’re the closest for me. It’s disheartening that they don’t really have a chance in my riding though.
Didn’t say I wasn't going to vote. I just don’t like my options.
No pretending to ride a motorcycle
I’m so fucking tired of all this right vs. left bullshit. They all suck. No one in charge or who wants to be in charge seems capable of nuance. Maybe that’s a reflection of the general public, I don’t know but it’s exhausting.
Good call on a deep clean. I’m sure you’ll figure it out. I think it’s a lot of trial and error for most people at the beginning.
That piece on the FEP sheet is where it let go from the supports when the build plate lifted. More support will probably fix that.
I always think about what’s happening when I’m doing supports. The resin gets cured on the FEP then the build plate moves up and pulls that layer off the FEP. The part is being pulled by forces in opposite directions so we need to make sure that the part hanging on to the build plate is sufficiently anchored so it’ll pop off the FEP and not off the build plate.
Any time!
If it didn’t print at all I’d be looking at that USB right away. I had many half printed things and corrupted files before I clued in.
I started resin printing a couple months ago. I had some of those layer problems too. I found that I need way more supports than I thought I needed at the beginning. This is a pretty good guide on supoorts. Alternately Ive been using lychee slicer’s auto supports. They seem to work well for the most part.
I also just recently did some exposure tests. It takes a while because each test is about 20 minutes but it turns out I was under exposing my prints so things are better now.
Lastly I replaced the usb stick the printer came with. I highly recommend doing this right away, a bad stick can do weird things. I got two 64gb Kingston data travellers for $10 Canadian. It’s well worth it.
Haven’t had the layer issues since I did these things and, fingers crossed, I haven't had a failed print since either.
There’s an extra leg in that first one right? It’s messing with my head.
Lucky for me I can’t afford a new car anyway. I’ll just keep driving my unconnected car.
Recreating that scene from Casino Royale?