3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or [email protected]
There are CAD communities available at: [email protected] or [email protected]
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
Be respectful, especially when disagreeing. Everyone should feel welcome here.
No porn (NSFW prints are acceptable but must be marked NSFW)
No Ads / Spamming / Guerrilla Marketing
Do not create links to reddit
If you see an issue please flag it
No guns
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
Printer Artillery Genius. I've used Cura slicer, but any custom support setting will do👌.
After that i primed the model so any eventual imperfection disappeared.
Wait so what was the trick to save time and filament? Just rotating the part to use fewer supports?
Exactly🫵
For me skipping 1_2 hour of printing time is a win, and saving a bit of pla is not too bad either. Also, a print complely covered in supports may be quite a pain to clean.
Nice one, I should look into rotating models too.. But once opening the slicer, I just lost patience lol
These look so great! What do you do to prime them and clean them up like this?
Superglue+bakinsoda to close gaps and streight small parts (as the tentacles) > A light sanding > Car primer and wet sanding (standard first then 1200p) > repeat until it looks good enough 👌💫
btw. The lil Cthulu is aroud 3 inches.