199
If you're on the fence about building or buying a 3d printer enclosure, please let me give you a push.
(sh.itjust.works)
I should have built this thing from the word go. I ran this printer for almost a year on my desk right next to my computer. But it was loud and smelly and the high traffic area played havoc on print quality and caused a lot of warping.
Now that it's tucked away in a back room suspended in a corner by French cleats and sitting directly on top of dense foam and a big ass paver it is merely "audible" but certainly ignorable. There's also no more headaches from the smell, and my print quality has never been better.
Do yourself and your printer a favor and get an enclosure sorted out asap.
Mind showing some build pics if you got them? I'm probably going to make one out of 1/4" plywood I have left over. Some build tricks would really help.
I don't have any build pics for you unfortunately. I would really recommend using at least 1/2 inch plywood for this kind of build though. I went 3/4 because I was worried 1/2 inch would vibrate too much. The enclosure needs to have more mass than the printer to reduce the risk of vibrations effecting print quality. Plus I'm not even sure what kind of fasteners you'd be able to use to secure 1/4 inch plywood that would hold the weight of a paver and printer.
I made mine with pocket holes and glue. Disclaimer though, I am a carpenter. I'd say this a pretty good starter project if you want to get on YouTube and learn. This is basically a cabinet carcass mounted on the wall with French cleats to give you some terms to research. Good luck! Just holler at me if you have any questions.