I believe this was caused by the horrendous layer adhesion of this silk PLA. Didn't have time to tune the filament, and based it off of another silk one.
this post was submitted on 30 Apr 2025
130 points (97.1% liked)
3DPrinting
18268 readers
87 users here now
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or [email protected]
There are CAD communities available at: [email protected] or [email protected]
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
@anguo Actually it seems like your bed slipped halfway (see the sudden misalignment on Y axis clearly visible on the bowl) and even though printer kept printing well afterwards, it propably reached some point where it started printing "into the air"
I just retightened the belt and lubricated the rods a week or two ago, after another failure, not sure what could have caused the slip