3DPrinting

16273 readers

52 users here now

3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.

The r/functionalprint community is now located at: or [email protected]

There are CAD communities available at: [email protected] or [email protected]

Rules

No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
Be respectful, especially when disagreeing. Everyone should feel welcome here.
No porn (NSFW prints are acceptable but must be marked NSFW)
No Ads / Spamming / Guerrilla Marketing
Do not create links to reddit
If you see an issue please flag it
No guns
No injury gore posts

If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![](URL)

Moderation policy: Light, mostly invisible

founded 2 years ago

MODERATORS

[email protected]

Picked up an AnyCubic 4Max Pro (lemmy.world)

submitted 2 years ago by [email protected] to c/[email protected]

3 comments fedilink hide all child comments

Hey everyone,

I just grabbed an AnyCubic 4Max Pro for insanely cheap. I had to swap out the hot end, it was bent. It seems the last owner had the Z limit switch incorrectly set so it was crashing.

So far it's printing fairly well. I need to do all the calibration and such, but for 'out of the box' it seems to be alright.

I've been reading up on the hardware itself and it seems to be fairly crippled due to the board AnyCubic used. An 8 bit board based on the Arduino Mega. I've see lots of pre-conpiled firmware for Marlin 2.0.x but they're usually filled with even more bugs than they solved. The board is called TriGorilla? Honestly I'm use to BTT and Crealitys boards.

Has anyone done a board swap on this? I saw the LCD is a hack job by AnyCubic since Marlin, maybe at the time?, Didn't support DWIN touch screens. I'd like to keep the stepper drivers, so maybe a board that has removable?

Thanks Henry

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 1 points 2 years ago* (last edited 2 years ago)

Technically you could throw in edit Klipper based board if you wanted to dive into setting up the firmware. It would not surprise me if there isn’t already a klipper or Merlin profile for it. I’m currently converting a tronxy x5sa 400 pro over to a maker base klipper board setup. And even that printer has a profile out in the GitHub that I can modify a bit.