Right to Repair

1764 readers

7 users here now

Whether it be electronics, automobiles or medical equipment, the manufacturers should not be able to horde “oem” parts, render your stuff useless if you repair it with aftermarket parts, or hide schematics of their products.

I Fix It Repair Manifesto

Summary article from I Fix It

Summary video by Marques Brownlee

Great channel covering and advocating right to repair, Lewis Rossman

founded 2 years ago

MODERATORS

[email protected]

Need help fixing an oven (discuss.tchncs.de)

submitted 1 month ago* (last edited 1 month ago) by [email protected] to c/[email protected]

16 comments fedilink hide all child comments

Hey, I've got a faulty oven here that won't heat up properly. The previous owner suspected a defective heating coil, but they are all functional. I tested it with an oven thermometer: if only bottom heat is on, the thermostat switches correctly and the oven heats up as it should. However, as soon as top heat is (also) on, it only heats up to about 80°C (144°F) below the target temperature.

The sensor is located directly behind the upper coil, so it doesn't seem too far-fetched that it switches sooner in this case, but 80 degrees too early? It has been working for the past 12 years... In YouTube videos, a faulty thermostat seems to cause the stove to heat non-stop.

Any idea on how I can fix this? I don't want to buy a spare part only for the problem to persist in the end.

Edit: This is about an IKEA FRAMTID OV9 featuring an EGO 55.17253.120.

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 1 points 1 month ago (7 children)

I might have phrased that a little ambiguously. The thermostat does not switch off at 80 degrees, but 80 degrees below target temperature (set 150, reached 70).

The replacement thermostat is 40€, which is more than I usually intend to spend on a repair, so it would be a shame to buy it and find that the fault is still there.

[–] [email protected] 2 points 1 month ago* (last edited 1 month ago) (4 children)

If you're handy/industrious enough you can get a simple thermostat like an EGO 55.18062.050 which are fairly cheap and use that as a diagnostic tool.

If that solves your problem, you can swap out for the expensive part or leave in until it dies.

I've had thermostats fail open or closed. Open meaning the element never switches on or closed meaning the element never switches off.

I'm not an expert, just a hobbyist.

Is your thermostat probe in the proper place and the element isn't hanging off a bracket in the wrong place? Any improper placement of either may be giving an incorrect temp reading on the probe

[–] [email protected] 1 points 1 month ago (2 children)

Placement looks okay to me, sure is dirty up there though. Could that be the issue?

[–] [email protected] 1 points 1 month ago (1 children)

Minor dirt, nothing to worry about in terms of temps but don't let your mom see it XD.

Is there only one thermostat?

[–] [email protected] 2 points 1 month ago

I was about to say yes, but there was one part left that I wasn't sure what it is, so I checked. The casing says ELTH 271P / T200, which from what I can gather is a thermal cut-off switch. A potential problem cause?

The active one out of two top heating coils measures 3.6A, roughly 800W at 230V. Seems alright and should not trigger it I guess.

load more comments (1 replies)

load more comments (3 replies)