I'm looking to replace a panel of my computer mouse with a 3D printed part. I don't want to create a permanent bond (such that it can be changed out in the future), so I was considering something like rubber cement or silicone caulking to affix it. Thought I would check with those more knowledgeable as to the suitability of those options/suggestions for others.
Thanks in advance.
P.S. Not my pictures.
Huh. I’m doing the exact same part replacement soon. Wish Logitech just used the same grippy plastic finish that they used to have on models like the G700 instead of this short-lifespan rubber garbage.
I was wondering how the model was sculpted and if it could be extended to replace the entire rubber part, as it would leave some internal plastic exposed as it is, assuming you’re looking at the same STL I was looking at. Perhaps I should just reach out to the author of the model.
I hadn’t committed to an adhesive, but I distinctly remember one or more commenters just using regular double sided tape. It’s not like the tape is load bearing. You can just pull the part off with enough force and patience, especially if you don’t care about salvaging the part.
Yeah, the model not being a full replacement of the rubber part was annoying. I used an Xacto knife to cut the rubber before removing it, leaving it in place where the replacement didn't reach. There is no wear and tear that far up the mouse so it doesn't look half bad.