this post was submitted on 20 Apr 2025
103 points (97.2% liked)

Electricians

157 readers
1 users here now

For those in the Electrical trade

founded 2 years ago
MODERATORS
 

Not one I've seen before. Trust no one, not even your helpers

you are viewing a single comment's thread
view the rest of the comments
[–] [email protected] 9 points 1 week ago (3 children)

Clearly that is bad… but how bad? Like burn it down bad?

[–] Undearius 18 points 1 week ago* (last edited 1 week ago)

The metal on that light switch would be live any time the other light switch (on the other end of the red traveller wire) is turned on.

If that box is metal, it would make the metal brackets of the other switches live as well, and assuming one of the other switches is properly wired, it would just go back to the panel on the ground wire.

I think that would either complete the circuit and the device would turn on, or it would ground the circuit and pop the breaker. The same would likely happen with this switch as well considering the ground is wired on the hot terminal.

I'm also not an electrician so this is a full-on guess.

[–] [email protected] 8 points 1 week ago

Wiring hot directly to ground will create a short circuit. Ideally that causes the breaker to flip immediately enough to stop anything bad from happening as the amperage jumps. But it can melt wires, fry electronics/outlets/switches, cause sparks to fly, create a shock hazard, or start a fire, yes. The breaker is there to "ideally" prevent that, though they can fail. I'm also not an electrician by trade so I'm really not sure, but i wonder too if one could fuck up the wiring bad enough to cause a short in parallel to the breaker that doesn't even trip it. If old boy is sticking the ground wire into hot switches, I would question what other dumb shit he might have done.

[–] [email protected] 6 points 1 week ago

"attempted murder", now honestly what is that? Do they give A Nobel prize for attempted chemistry?