Motorcycles

2856 readers

1 users here now

Here we discuss everything related to riding, maintenance and gear.

Rules:

Be respectful and inclusive.
No harassment, hate speech, or trolling.
Engage in constructive discussions.
Share relevant content.
No advertising or self promotion.

founded 2 years ago

MODERATORS

[email protected]

I did a thing today! New front tire and fork seals (imgur.com)

submitted 2 years ago by [email protected] to c/[email protected]

13 comments fedilink hide all child comments

Holy fuck, that was rough. The guides and the videos show the uppers and lowers pulling apart easily. I had to clamp the lowers in the vice and use the uppers as a slide hammer and repeat the bang bang bang process for 5-10 minutes, with the seal moving almost imperceptibly as it walked it's way out.

Putting the upper bushing back in took a trick, it is a split ring, and is expanded too big to fit in the recess unless you compress it. I found that I could take some brake bleeding hose and cut off about 4" of it, and hammer it in with a punch between the bushing and the lowers. This worked to compress the bushing, and I could then place the washer over it and hammer it down about halfway, and then pulled the washer and hose out and then drive it home.

Tomorrow I get to get back at it and tackle changing the rear tire.

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 1 points 2 years ago

No harm in trying it out. If you can't feel anything at speed, send it.

Impressive tires tho. Second biggest improvement after installing Racetech gold valve emulators and proper rate springs.