this post was submitted on 31 Jul 2023
31 points (100.0% liked)

Arduino

573 readers
1 users here now

This is an UNOFFICIAL Arduino community.

Everyone who uses Arduino board or their clones or associated boards and/or the Arduino IDE is welcome here. If it involves Arduino hardware or software it's welcome here. If it connects to Arduino hardware it's welcome here. If you're building your own boards that you use with an Arduino it's welcome here. There will be no Arduino elitist bullshit in this community.

You may also be interested in:

AVR

RULES:

  1. It's always a floating input.

  2. All Lemmy.ca rules apply here.

  3. Everyone (see rule 98) is welcome.

  4. If you’ve seen a question 100 times answer it the 101st time or ignore it. Even better, write a complete, detailed answer and suggest that the mod(s) pin it to the community.

[Did you actually think there were 98 rules?]

  1. If you present something as fact and are asked to provide proof or a source provide proof or a source. Proof must be from a reliable source. If you fail to provide proof or a source your post or comment may be removed.

  2. Don’t be a dick. Yes, this is a catch-all rule.

  3. The mod(s) have the final say.

founded 2 years ago
MODERATORS
MapleEngineer
MapleEngineer@lemmy.world
31
This is how I take something from a breadboard through prototype to finished product. (lemmy.ca)
submitted 2 years ago by MapleEngineer to c/arduino
3 comments fedilink hide all child comments
 

I needed some LEDs so that I could track what my data lines were doing. I started with a bunch of LEDs and resistors on a breadboard.

From there I made up a small block of SMD LEDs and resistors on a piece of proto board.

Then I moved to an actual prototype on a dedicated protoboard.

Finally, I produced the finished product. BLINKY LIGHTS!

The friend who I work with can design a board entirely in software, we use Pulsonix, without every making a prototype, send it for manufacture, and get working boards back. Even when I build multiple prototypes I often end up with boards that need FECs to make them work.

top 3 comments
sorted by: hot top controversial new old
[–] Chriszz@lemmy.world 2 points 2 years ago (1 children)

Literally wondered about this yesterday

[–] MapleEngineer 2 points 2 years ago

My friend who does most of the design work says I should start with a schematic and parts and then use that to build the board. I need to learn that but I'm an amateur hack when it comes to this stuff and I just brute force the board design. I bought a hobbyist version of Pulsonix so I really should learn how to do it.

I started with the free version of DS PCB. It works very well.

Maybe this year.

[–] doppelgangmember@lemmy.world 1 points 2 years ago

Neat