grue

TL;DW: as fucking always, it's single-family zoning:

I think instead of making it impossible to build more affordable housing in safer places, and incentivizing people to rebuild in fire-prone areas, maybe the government could do the fucking opposite for once and make it easier to build in places that don't burn down once a decade! The state's response to these neighborhoods going up like kindling cannot only be to replace the kindling just as it was, just where it was, as quickly as possible, and at a taxpayer-funded discount. That is not bravery; that is not resilience; that is denial.

Climate change is only going to make these fires more frequent, and we have a glaringly obvious solution to make California safer in the face of them: we could rezone the city to allow more housing in areas that don't border the fire zone. But that is a solution that our cowardly politicians refuse to try, for fear of pissing off the homeowners who don't like apartment buildings!

cross-posted from: https://sopuli.xyz/post/21517409

cross-posted from: https://feddit.org/post/6623846

cross-posted from: https://lemmy.world/post/24007336

I've been using Linux exclusively for over seven years now, including for gaming (believe it or not), but only now is the first time I've been in the mood to get mods for my TES games working.

Anyway, I searched how to do it and, as per usual when it comes to Linux, found a bunch of different instructions documents with a bunch of different approaches. Anybody have an opinionated recommendation for the one that's the most up-to-date/preferred by the community currently?

cross-posted from: https://lemmy.bestiver.se/post/168662

Comments

cross-posted from: https://lemmy.world/post/23316613

I'm in the process of replacing all my single-color christmas lights with addressable RGB LEDs, but the 12mm "bullet" form factor of them is different from the traditional incandescent mini lights, the 5mm wide angle LEDs, etc.:

You'd think they'd make C6/7/9 bulb covers that attach to them, but I have yet to find any for sale, anywhere. As such, I want to 3D print some, along with 12mm bullet pixel-sized replacements for my snowflake lights:

What's some good filament I can get that will be reasonably clear and stay that way (without yellowing or getting too brittle) for several years' worth of Christmas seasons, despite UV/rain/cold exposure?

(Bonus question: anybody know a good way to model the facets in those "strawberry" lights? The C7 bulbs on Thingiverse, such as this one, are all smooth, LOL.)

Edit: by the way, to be clear (pun intended): I don't need optical clarity like the lens guy; scattering the light is fine. (In fact, doing that on purpose is kind of the point of modeling a faceted C7 bulb instead of a smooth one.) I just want to make sure that whatever part of the filament that doesn't manage to be transparent is white, not tinted some dingy color.

I do happen to have some Inland "natural" PLA laying around and did a test print in that. It's not too bad -- only a little bit yellow at the wall thickness I'm using -- but I fear for how it will hold up over time.

Me a few days ago, shopping on Amazon: "All the component and jumper wire leads are going to be on the bottom anyway; why shouldn't I get a pack of single-sided breadboards for $6.25 instead of double-sided ones for $10?"

Me today, after having lifted three pads off the damn board in 10 minutes: "Oh, that's why."

Get the double-sided breadboards; they're worth it.