So my relatively new s&w m&p15 won't cycle the action when shooting. The hammer will reset but the bolt wont move at all. This happens with several different ammos, both winchester 223 and winchester/ federal 556.
First thing i did was clean and oil it. No difference.
Then I checked the bolt seals and they are in good shape. When standing the bolt up on it's extractor side it doesn't move, but will with light pressure.
I figured something must be wrong with the gas tube so I blew some carb cleaner through the gas port in the action (the nipple that interfaces with the gas key on the bolt). I expected it to be blocked but the cc ran out the barrel unobstructed.
I covered the gas port (in picture) with a piece of masking tape when shooting and gas came out enough to discolor the tape but not blow a hole in it. I know that's not super scientific but nothing wrong with more info.
I honestly can't think of anything it might be. Any info helps, thanks
Have you checked that your recoil spring isn't jammed or obstructed?
Yeah it's in good shape. The rifle cycles manually, maybe just a hair more resistance than I'd expect but tbh this is a new platform for me.
They're pretty simple devices, so it sounds like there's probably an issue with your gas system. Can you take it back to where you bought it?
They're pretty simple devices, so it sounds like there's probably an issue with your gas system. Can you take it back to where you bought it?