3DPrinting
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or [email protected]
There are CAD communities available at: [email protected] or [email protected]
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
view the rest of the comments
Here's something that took me a while to realize and I haven't seen mentioned much: check where the start/stop points are on each layer (z-seam) and adjust so that they're not right on parts of the model that are small or need to be more precise (teeth, threads, hinge bumps, etc). I was having a real hard time with some print-in-place hinges, and the problem was that the layers were starting right near the hinge. The finer details were getting globbed up with the bit of extra filament there. Once I moved the z seam, it printed like a charm.