190
this post was submitted on 21 May 2025
190 points (99.5% liked)
Technology
38778 readers
315 users here now
A nice place to discuss rumors, happenings, innovations, and challenges in the technology sphere. We also welcome discussions on the intersections of technology and society. If it’s technological news or discussion of technology, it probably belongs here.
Remember the overriding ethos on Beehaw: Be(e) Nice. Each user you encounter here is a person, and should be treated with kindness (even if they’re wrong, or use a Linux distro you don’t like). Personal attacks will not be tolerated.
Subcommunities on Beehaw:
This community's icon was made by Aaron Schneider, under the CC-BY-NC-SA 4.0 license.
founded 3 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
I'll give it a shot too, since I have the razor for the one model they have released
https://www.printables.com/model/1289421-philips-fixables-oneblade-1-3mm-comb
It looks like they made those thin sections roughly 2x wider in the stl files to strengthen it. That makes me a little more optimistic.
It was a super fast print (about 16 minutes) so I went ahead. I think it'll be fine, and I even had a random layer issue on the back side. Put it on the razor, and it used the angle of the blade to lock it in place, so I don't think there will be much issue.
Lemmy is not letting me upload images on mobile, but I'll see if I can do it on desktop
They havent released one for the razor I have, but honestly I might try modeling them myself. Doesn't seem impossible, and I've been waning a deeper comb than they sell.
They aren't wildly complex, don't would be dobale for sure