Home Networking

Building to building bridge.

Direct burial cat6, a shovel and an AP or spare router with AP mode

Would be easier to set up a PTP and then run a cable inside with a AP.

I would recommend a semi-P2P solution.

Buy an older Ubiquiti Litebeam M5 or M2.4. Buy whichever signal you want to from your main router. The M5 would be Great if your laptop/phone has good 5GHz signal. Set up the LBE outside the shed where you plan to mount it. Give it an static IP based on your Network IP outside the DHCP range (e.g. the main router is 192.168.1.1 and dhcp gives 192.168.1.100-199, so give your LBE the IP 192.168.1.11). Access it again using the new IP, go to Wireless settings, disable AirMax, and connect it to your main router's WiFi. When its connected you are good to connect it to an AP (below).

Buy any router you can use as an Access Point. A cheap TP-link AX10 or any spare router your have. You'll need to set it to Access Point mode or disable DHCP at least. Then give it a static IP based on your Network IP outside the DHCP range (e.g. the main router is 192.168.1.1 and dhcp gives 192.168.1.100-199, so give your AP the IP 192.168.1.2).

Connect the LBE to the new "router" (now an Access Point) via lan-to-LAN ports. Careful not to use the LBE's PoE port. Voila!

I have an Asus AX56U (shed) in a mesh with an AX88U (house). The shed is 65 ft away and I just have the AX56U inside on a shelf, no external antenna outside the shed.

I haven't had any issues.

Mesh stuff *could* work, but there is a good chance it will be janky. If cable isn't an option, then point-2-point wireless is the second best option. It's basically similar to mesh, but with (1) separate communication channel for "backhaul", i.e. from the shed to the house, and between the access point and the clients, i.e. inside the shed. Further, (2) you can have separate, directional antennas for the backhaul. I'm pretty sure you will be happy with that.

However if what you want is just to use YouTube and some music on your phone, why not just use mobile data? 4G / 5G is pretty good!

Maybe it would be possible to cut a hole and make a small plastic "window" in the wall, and mount an ordinary repeater on there.

Go Wireless Point-to-point https://store.ui.com/us/en?category=all-wireless couple hundred bucks will get you almost gb throughput over the air as long as you've got line of site. Run remote exterior point-to-point to a poe switch inside then feed an indoor AP from that.

lol two mikrotiks one set as an ap client the other as a router. It’s less than $100

Maybe pick up a router compatible with ddwrt, one that has external antennas, and for one of the antennas, solder some leads to your metal building...

Get a mesh system and backhaul if you can.

PtP is best.

If you can run the wire for this outside you can run an ethernet cable outside and get a used point-to-point ubiquiti set on eBay..

That's what I would do.. 🤷

I know it has been mentioned at least once but your best bet is to get some kind of p2p bridge set up, I also recommend Ubiquiti as I've been using it for years.

Here is a lot of 3 nanobeams (you only need 2 but hey, a spare unit is always good) on ebay - https://www.ebay.com/itm/166387429389?mkcid=16&mkevt=1&mkrid=711-127632-2357-0&ssspo=S7op1P-wSV6&sssrc=4429486&ssuid=6BvfzwVFQsO&var=&widget_ver=artemis&media=COPY

You will need two 24v PoE adapters as they aren't included but are cheap https://store.ui.com/us/en/pro/products/u-poe-af

And you can get mounting accessories from Ubiquiti's website if you want them. https://store.ui.com/us/en/products/nbe-m5-16

Then just connect some kind of Access Point or old router at the other end for wifi access (if using an old router TURN OFF any routing/NAT/DHCP (aka bridged or AP mode) on the router and plug into one of the 1-4 ports and not WAN/Internet port unless the router specifically says to when bridged (if will be obvious if it says it))

House modem/router>--wired ethernet to nanobeam--> house nanobeam (in AP mode) )))wireless link((( bldg nanobeam (in station mode)>--wired ethernet to AP/Old Bridged Router--> AP/old bridged Router }}}wifi for building

While this route can be a bit more expensive depending on what equipment you get and a bit more involved, you're going to have a MUCH better experience than using some kind of repeater.

Edit: spelling and formatting

Ubiquiti 5AC loco PtP. Basically a wireless Ethernet cable. At 30-40ft, these will be rock solid, probably even through a thick forest of trees.

https://www.bhphotovideo.com/c/product/1382616-REG/ubiquiti_networks_ns_5acl_us_nanostation_5ac_loco_us.html