ExcessShiv

i want to remove specific trackers from all my torrents (they're discontinued), it's not doable with a per-torrent method as i would never finish.

I'm using qbittorrent v5.0.3 WebUI, i cannot just select the trackers i wish to remove under the "trackers" pane in the left side as it only allows me to remove all torrents with this tracker (i do not wish to remove the torrents), and not remove the tracker.

how can i remove these trackers from all my torrents easily, while keeping the torrents for seeding?

when I run on my treadmill, it has suddenly started feeling like it briefly stops the belt whenever I land my stride. I've tried greasing the board underneath the belt with silicone grease according to the manual, but that didn't help. Any advice on how to fix this? Could it be the belt that needs tightening?

[SOLUTION] It was just belt tension, it had become too slack. A quick tightening fixed the issue completely.

I currently have two TVs, one I use an appleTV with and the other with a googleTV HD (device formerly known as Chromecast), but they both have issues.

The jellyfin app on appleTV is messed up, it fucks up audio and subs all the time, and in general has a hard time with media that has multiple audio tracks, not using the audio I select with the remote.

The googleTV just stutters with almost everything, direct stream or transcoded doesn't matter. All of my library is just 1080p, I have proper wifi to it, all mobile devices stream just fine.

So neither of these provide me with a solution that really works.

What solutions can you recommend, that allows for seamless navigation of jellyfin with my remote? I don't want anything resembling a mouse/keyboard combo for navigation whatsoever.

I've been having some serious issues getting PETG to print well, and I was wondering what settings other are using with success? I'm using a bedslinger in an enclosure and normally i print PLA with 200mm/s.

What are you doing for nozzle/bed temp, cooling fan, printing speeds etc? enclosed/open?

What is your printer capabilities normally for e.g. PLA?

I have a cheap bedslinger, an Anycubic Kobra 2, and generally it's a pretty decent printer at the price. I have flashed klipper FW on it, so I'm not using Anycubics FW.

I have issues whenever I try printing bigger parts, the first layer is always complete shit (see post photo).

Heightmap, measured with inductive probe range is only 0.085mm from min to max, so it should be reasonably flat. The heightmap is automatically recalibrated and loaded as part of my print_begin macro.

Slicer settings for line width

I don't know if my printer just doesn't correct Z-height during first layer, if my line width settings are completely messed up or what is causing this, but the issue is only apparent on bigger parts with large contract surface on the bed.

[SOLVED] It was just Z-offset that was too low causing this. however when running the calibration routine from ellis3dp on first layer squish, the settings that looked good on the small calibration patches, looked like crap on bigger prints. I needed a bit higher Z-offset, but that solved it.