Woodworking

7210 readers

85 users here now

A handmade home for woodworkers and admirers of woodworkers. Our community icon is submitted by @[email protected] whose father was inspired to start woodworking by Norm and the New Yankee Workshop.

founded 2 years ago

MODERATORS

NataliePortland

Tablesaw featherboards? (lemmy.ml)

submitted 2 weeks ago by [email protected] to c/woodworking

10 comments fedilink hide all child comments

I'm making my own white oak door jambs. So far I did one set. I milled some rough cut oak, made two passes through the table saw to roughly remove a rabbet for the integrated door stop.

Then I ran it through the table saw again with a dado stack to get the rabbet to the final dimensions. The problem is, it's difficult to apply even pressure as the wood passes over the dado stack. I already have a featherboard pushing against the fence, but I'm thinking I could use another pushing against the saw top.

I know I can put one on my fence, but that would apply pressure to the part of the board closest to the fence only. Do they make any contraptions that can apply even pressure downwards, but over a larger surface area? Like multiple featherboards extended out over the work piece.

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 3 points 2 weeks ago

You can make your featherboards any shape and stiffness you want. A wide short one for the fence, pretty stiff and barely pushing on the material from above (just enough to keep it from rising up, really) along with a dado depth support directly behind the stack sounds like it'd do it.