Woodworking

7168 readers

6 users here now

A handmade home for woodworkers and admirers of woodworkers. Our community icon is submitted by @[email protected] whose father was inspired to start woodworking by Norm and the New Yankee Workshop.

founded 2 years ago

MODERATORS

NataliePortland

Best way to flatten a piece? (lemmy.dbzer0.com)

submitted 6 days ago by [email protected] to c/woodworking

12 comments fedilink hide all child comments

Can anyone tell me how can I flatten a Minecraft heart please? I've put this together:

https://www.instructables.com/MineCraft-Heart-wood/

but I've noticed that it bows slightly. I've managed to get the ends to raise slightly when I've screwed it together. The top needs to be smoothed too, as there are some small differences between the pieces. Both sides are only off by a millimetre or two, but it's enough to be noticeable.

My thinking is to clamp it down at the centre, which seems to be mostly flat on both sides, then sand the top until it's level, then flip it over and clamp the edges to smooth the bottom.

Are there any likely problems with doing it this way, or is there a better way of doing it? Thanks in advance :)

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 1 points 2 days ago

I wouldn't have thought that tape would be enough. It's definitely worth a try though, thanks :)

It's a bit too big to hold against the orbital sander, but I was thinking of clamping some wood that's the same thickness to either side, then screwing those to a bigger piece attached to the table, so the scrap pieces act like a clamp. That should hold the heart in place, and give me a reference of the correct thickness to either sand or route. Maybe...