mst

joined 2 years ago
[–] [email protected] 2 points 3 days ago (1 children)

Ja, außer bei Aldi, die haben eigene Gläser ohne Pfand.

[–] [email protected] 1 points 6 days ago

Ist der Artikel eine schlechte Zusammenfassung eines Videos oder übersehe ich da was?

[–] [email protected] 31 points 6 days ago

Bisher war es meistens so, dass einen der Frauenarzt dann für ein paar Wochen krank geschrieben hat. Aber gut, dass das mal vernünftig geregelt wird.

[–] [email protected] 1 points 1 week ago

Fände ich an sich garnicht schlimm. Immerhin baut der Netzbetreiber auf meinen, nicht auf seinen Wunsch, einen anderen Zähler ein. Aber dann muss es auch bei einem einmaligen, angemessenen Preis bleiben.

[–] [email protected] 3 points 3 weeks ago (1 children)

https://www.atlas-alltagssprache.de/runde-7/f01a/

Um das ganze mal wissenschaftlich zu klären.

[–] [email protected] 2 points 3 weeks ago (1 children)

Je nachdem, um was für ein Gebäude es sich handelt hast du Anforderungen was den Brandschutz angeht.

[–] [email protected] 2 points 3 weeks ago (1 children)

Ich wage zu behaupten, dass da so manche Verkäuferin nur arbeitet um Selbstständig zu sein und nicht um Geld damit zu verdienen. Das kann zB fürs Elterngeld nützlich sein.

[–] [email protected] 2 points 1 month ago

Seam is at another position, far away from that part.

[–] [email protected] 4 points 1 month ago (1 children)

Checked the screws and tightend them up a bit.

[–] [email protected] 2 points 1 month ago (1 children)

Just a band. But not all the was around. It is at overhangs and a little bit after them. But not before overhangs.

[–] [email protected] 6 points 1 month ago* (last edited 1 month ago) (8 children)

Started the print again because i need this part multiple times anyway. It starts to "fail" at the same corner again.

Edit: Not exactly the same damage, but at the same height. Looking at the last print, it's not just that corner, it's all around at the same height.

 

What could cause the strange part on the right? The whole surface should be the same, it's a 90° wall, so nothing that should look like this. Can't see anything strange in OrcaSlicer. BambuLab A1 Mini with Creality PLA+

[–] [email protected] 2 points 1 month ago

Thanks for your detailed answer. I'll probably need about 50-100 pieces each. I got an good deal for some 250g spools on aliexpress, should be enough.

 

I wanted to print some tokens for a boardgame which need different colors. I don't need that much colored filament. I came across that set while searching for cheap filament. Is that a good deal or would it be better to just buy full spools, even if I dont know what to use it for?

 

Die Ampelkoalition ist offenbar gescheitert: Übereinstimmenden Medienberichten zufolge entlässt Bundeskanzler Olaf Scholz Finanzminister Christian Lindner von der FDP.

view more: next ›